The MARK2-Load Sum-Pin Type
device will give you both a slack rope setting and an overload setting. The settable electronics has n/c relays available.
Clamp the electronic load cell portion to the non-moving end of the wire rope on the hoist (dead end). The second part of the package goes into your control panel which is settable for both slack and overload. It has n/c (normally closed relays) with which the up direction or down direction of the hoist motion can be controlled. A four wire cable connects the parts. It comes with a 12 vdc power source DIN rail mountable. There will be a load pin required for each hoist and separate data will be required for each hoist.
EMAIL [email protected]
for a full quotation (the website is under construction on this part)
Please give the tonnage of the hoist, values you wish to trip at overload and slack weight setting. We will require the sheeve pin specifications where you wish to place the load pins that will be specially designed for your application. Tell us where that pins are located on the reevings , along with falls of rope for each hoist. Load summing can be accomplished for multiple hoists also beyond 2. Request a quote.
A specification sheet will be sent to you to fill out for the load pin specs you require.